Section 5: Service; Troubleshooting - Grizzly T32428 Owner's Manual

SECTION 5: SERVICE

Review the troubleshooting procedures in this section if a problem develops with your equipment. If you
need replacement parts or additional help with a procedure, call our Technical Support. Note: Please
gather the serial number and manufacture date of your equipment before calling.
Operations
Symptom Possible Cause
Roller will not 1. Roller axle requires lubrication.
turn smoothly.
2. Bearing inside roller has failed.
Roller system 1. Hinge and pivot point require lubrication.
will not lower.
2. Folding support arm fasteners are too tight.
Rollers are 1. Roller frame adjustment plate is adjusted
not parallel
incorrectly.
with table saw
surface.
Model T32428 (Mfd. Since 11/21)

Troubleshooting

Possible Solution
1. Clean and lubricate roller axle (Page 16).
2. Replace roller.
1. Clean and lubricate hinge and pivot points (Page 16).
2. Loosen fasteners.
1. Adjust roller frame adjustment plate (Page 11).
-17-