Barco R9002410 Owner's Manual page 38

Total Run Time
Highlight Total Run time using the arrow keys and then press ENTER to
display the total time the projector has run since its first start up at the factory.
EXIT returns to the Service Mode menu.
Note : All projectors leave the factory after a burn-in period of
approximately 100 hours.
Change Password
This item is password protected.
Highlight CHANGE PASSWORD using the arrow keys and then press ENTER. The current password is displayed. The new
password must consist of 4 digits, 0 to 9. Select the digit to be changed with the arrow keys and use the numeric keys to enter
the new digits.
Press ENTER to save the new password. Before saving, a confirmation screen will be displayed.
Press EXIT to return to the Projector Setup menu without saving the new password.
When the displayed password is correct, press ENTER to save.
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
POWERUP MODE : Standby
Select with
Change Language
Using the arrow keys, highlight CHANGE LANGUAGE and then press Enter to display the list of languages available for the screen
displays. The following languages are available :
- English
- Spanish
- French
- Deutsch
Highlight the language of your choice and then press ENTER.
Pressing EXIT returns to the PROJECTOR SETUP menu.
R5976101 BARCO CINE 5 ___________________________________________________________________________________
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE LANGUAGE
CHANGE BAUD RATE
COMMON ADDRESS
or
then <ENTER>
<EXIT> to return
If not correct, press EXIT to cancel the saving.
PASSWORD
ENTER NEW PASSWORD
0 0 0 0
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
POWERUP MODE : Standby
COMMON ADDRESS
or
Select with
then <ENTER>
<EXIT> to return
Service Mode
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
POWERUP MODE : Standby
COMMON ADDRESS
or
Select with
then <ENTER>
<EXIT> to return
PASSWORD
Password will be
reprogrammed as
<ENTER> to
<EXIT> to return
LANGUAGE
ENGLISH
ESPANOL
FRANCAIS
DEUTSCH
or
Select with
then <ENTER>
<EXIT> to return
7-3