Controlling; Battery Installation In The Rcu - Barco R9002410 Owner's Manual

4

Battery installation in the RCU

2 new batteries are delivered inside the plastic bag with the power cord.
Remove the battery cover on the backside of the remote control by pulling the indicated lever a little to the bottom of the RCU.
Lift up the top side of the cover at the same time (fig. 1).
Insert the new batteries (AA type or equivalent) in the compartment according to the markings in the compartment, and put the
cover back.
The projector can be controlled with
a. The RCU
b. The hardwired RCU (cable not included)
c. The local keypad.
Controlling the projector with the RCU and the hardwired RCU is the same.
R5976101 BARCO CINE 5 ___________________________________________________________________________________

CONTROLLING

Batteries
CAUTION : Do not display a stationary image
with full brightness and contrast for longer
than 10 minutes, otherwise you disk damage
to the tubes.
Before using the RCU, install the batteries.
Battery Compartment
Cover
Controlling
4-1