Barco R9002410 Owner's Manual page 9

2
LOCATION AND FUNCTION OF CONTROLS
REAR PANEL TERMINOLOGY
1. Communication port (800 peripherals)
- allows communication between the RCVDS switcher and the projector.
- allows connection of a remote IR receiver unit to the projector.
2. IR Remote - Remote input for wired remote control
3. IR sensor - Receiver for control signals transmitted from the RCU.
4. RGB-S IN or (R-Y)Y(B-Y)-S IN ( 5 x BNC connector ) :
RGB-S in : allows a character generator, microcomputer, video camera, etc. having analog RGB output to be connected to
the projector.
Line inputs : - signals RED-GREEN-BLUE
- COMPOSITE sync. signal or Hor. sync
- Vertical sync
5. VIDEO IN ( Composite video, 1 x BNC) connector allows a video tape recorder, video camera, color receiver/monitor,
etc. having video line output to be connected to the projector.
6. S-VIDEO IN: Separated Y/C (luma-chroma) signal inputs and outputs for higher quality playback of Super VHS signals. (4-
pin S-VIDEO connector).
7. Auto diagnosis display
8. Local key Pad
9. Power (Mains) Switch: Depending on the software set-up of the projector during installation, the projector switches to
'standby' or to 'operational mode'. If in standby, the standby led in the
10. Power (Mains) input: Connect the supplied ac power (mains) cord here and to the wall outlet.
11. Audio Output : Only if the Tuner option is installed. Audio out to be
12. RF input : Only if the Tuner option is installed. Input for RF signals from a TV cable network or TV antenna.
13. RS 232 : Allows connection to the serial port of a Computer for controlling the projector.
Front Panel Terminology
1. IR SENSOR : Receiver for control signals transmitted from the RCU.
R5976101 BARCO CINE 5 ___________________________________________________________________________________
2
11
12
13
8
7
6
STD BY / NORMAL
PAUSE
COINCIDENCE
EHT HOLD DOWN
IR CODE RXD
1
Locations and Functions of Controls
3
1
4
5
auto diagnosis display lights up.
connected to audio amplifier.
9
10
2-1