Preparation For Sewing - JUKI PS-900-13090 Instruction Manual

4-20. Preparation for sewing

❷ ❷
❸
B B A A
6) Reading the sewing pattern data
1. In the case an electronic label is attached to the pattern, the electrical system will automatically identify
the sewing pattern program that matches the pattern from among those stored on the electronic label.
2. In the case no electronic label is attached to the pattern, manually select the sewing pattern data that
matches the relevant pattern on the operation screen.
* Refer to "4-22. Configuration of the operation panel" p. 56
1)
2)
❶ ❶
3)
4)
5)
B B
– 51 –
Turning ON the main power switch.
Press switch ❶ to turn ON the main power sup-
ply.
Turning ON the main air source switch
Move main air valve ❷ to the right to open the
main air source.
* If the operation panel freezes after you have
turned the power ON, check whether the opera-
tion panel cable is connected properly.
Resetting the equipment
When the equipment is reset by pressing
❸ , the needle stops at its upper stop position,
and the disk presser and intermediate presser
go up.
Read the pattern data to be sewn, or directly
edit the pattern data on the operation panel.
Refer to the Instruction Manual for the comput-
er-control system for details.
Attaching a pattern
Moving an empty pattern (with no material), fit
positioning hole A on the pattern positioning
plate on the positioning pin. Fit other two aux-
iliary positioning holes B on the positioning
sleeves and fully push them until they will go no
further.
for how to use the electronic label.