Subclass Model; Barcode Reader - JUKI PS-900-13090 Instruction Manual

6. SUBCLASS MODEL

6-1. Barcode reader

WARNING :
Be sure to turn OFF the power supply and air supply to the sewing machine before attaching the
parts in order to protect against accidents caused by an unintended start of the sewing machine.
❸ ❸
❹ ❹
❽ ❽
❼ ❼
❾ ❾
❶ ❶
❷ ❷
❺ ❺
60 ± 5 mm
– 91 –
1) Secure barcode reader ❷ and assembly plate ❶
with screw ❹ .
No. Part number Part name
❶
40269588 Barcode reader
assembly plate
❷
40235199 Barcode reader
❸
40235588 Screw
❹
40235200 Screw
❺
40235332 Washer
❻
40235331 Barcode
2) Close the regulator and pull out the air
tube ❼ .
Remove the screws ❽ (2 pieces) from
the switch assembly base ❾ , stack
the assembly plate ❶ and the switch
assembly base ❾ (see the left figure
for the position), and tighten ❶ and ❾
together with the screws ❸ (2 pieces).
Finally, insert the tube ❼ and open the
regulator.
3) Adjust the position of barcode reader ❷ so that it
is spaced 60±5 mm. Then, secure it with screw ❹ .
Connect the plug of the bar code reader to the
panel.
When bundling the barcode cable, slightly
loosen the cable near the barcode reader.
Quantity
1
1
2
2
2
1