Table of Contents
Advertisement
installation
Rigid Pipe Venting Systems
The minimum components required for a basic horizontal termination are:
1
Horizontal Termination Cap
1
90
Elbow
o
1
Rigid Pipe Adaptor
1
Wall Thimble
1
Length of pipe to suit wall thickness
(see chart)
1
4" x 6-5/8" to 5" x 8" increaser for 5" x 8" venting
Wall thickness is measured from the back standoffs to the inside mounting surface
of termination cap. For siding other than vinyl furring strips may be used, instead
of the vinyl siding standoff, to create a level surface to mount the vent terminal.
The Terminal must not be recessed into siding. Measure the wall thickness including
furring strips.
If a Vinyl Siding Standoff is required (it must be used with vinyl siding), measure
to outside surface of wall without siding and add 2 inches.
Horizontal and Vertical
Terminations for 4" x 6-5/8" Venting
Vertical
Terminal
Storm Collar
Flashing
943 or 943S
Ceiling Firestop
Pipe Length
The FPI AstroCap
and FPI Riser Vent terminal are certified for installations using FPI venting systems as well as Simpson Dura-Vent
TM
can Metal Products Ameri Vent Direct Vent, Olympia Ventis DV, Security Secure Vent
Fireplace Products International Ltd. Dura-Vent® and Direct Vent are registered and/or proprietary trademarks of Simpson Dura-Vent Co. Inc.
30
| Regency Excalibur
Vinyl Siding
Standoff (Optional)
Adj.Pipe Length
o
90 Elbow
Pipe
Length
Rigid Pipe Adaptor
P90EX Direct Vent Gas Stove
®
Wall Thickness
Wall Thickness
3-1/4" - 6-3/4"
7-3/4" - 16-1/4"
7-1/4" - 8-3/4"
4-1/4" - 5-3/4"
Horizontal
Termination
Cap
Wall Thimble
Alternate
Horizontal
Termination
Caps
, Selkirk Direct-Temp. AstroCap
®
Flat Wall Installation
Vent Length Required
(inches)
4" - 5-1/2"
7" - 8-1/2"
10" - 1-1/2"
9" - 14-1/2"
11" - 14-5/8" Adj. Pipe
15" - 23-1/2"
17" - 24" Adj.
Corner Installation
Vent Length Required
(inches)
11" - 14-5/8" Adj. Pipe
17" - 24" Adj. Pipe
WARNING:
Do not combine venting components from
different venting systems.
However use of the the AstroCap
Riser is acceptable with all systems.
This product has been evaluated by Intertek
for using a Rigid Pipe Adaptor in conjunction
with Duravent Direct-Vent, Olympia Ventis DV,
Selkirk Direct-Temp, Ameri Vent Direct venting
and Security Secure Vent systems. Use of these
systems with the Rigid Pipe adaptor is deemed
acceptable and does not affect the Intertek
WHI listing of components.
When using Rigid Vent other than
Simpson Dura-Vent, 3 screws must be
used to secure rigid pipe to adaptor.
is a proprietary trademark of FPI
TM
(inches)
6"
9"
12"
(inches)
6" + 12"
9" + 9"
6" + 9"
and FPI
TM
Direct Vent, Ameri-
®
Advertisement
Table of Contents
