Leds On The Supervisor-2 Module - Cisco MDS 9500 Series Hardware Installation Manual

Chapter 1 Product Overview
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
•
•
•
Caution Use only the CompactFlash devices that are certified for use with Cisco MDS 9000 switches and are
formatted using Cisco MDS 9000 switches. Using CompactFlash devices that are uncertified or are
formatted using other platforms may result in errors.

LEDs on the Supervisor-2 Module

The front panel on the supervisor module has the following LEDs:
•
•
•
•
•
•
The front panel on the Supervisor-2 module also includes a reset button (see
The LEDs on the Supervisor-2 module indicate the status of the Supervisor-2 module, power supplies,
and fan module.
Figure 1-13
OL-19587-01
Two USB ports provide a simple interface allowing you to connect to different devices supported by
Cisco MDS NX-OS. On the double decker connector, USB port 1 is on the lower position and port 2
is on the upper position.
Supervisor CPU subsystem based on Motorola PowerPC 7447.
Reset button that resets the Supervisor-2 without cycling the power.
External CompactFlash slot for an optional CompactFlash card provides a convenient way to boot
different images, back up the image, or store running-configuration data. The optional card can be
used for storing additional software images and configuration, debugging, and syslog information.
There is one LED that blinks when accessing this CompactFlash.
Status LED
System LED
Active LED
Power Management LED
MGMT 10/100/1000 Ethernet port LEDs (at right of the port):
– Link LED (on top)
– Activity LED (on bottom)
CompactFlash LED for external CompactFlash card
Table 1-4 provides more information about these LEDs.
Supervisor-2 Module LEDs
Cisco MDS 9500 Series Hardware Installation Guide
Supervisor Modules
Figure 1-13).
1-19