Cisco MDS 9500 Series Hardware Installation Manual page 212

Cisco MDS 9500 Shelf Bracket
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Installing the Switch on the Shelf Brackets
This section provides general instructions for installing the Cisco MDS 9509 Director on top of the shelf
brackets. For detailed installation instructions, see
on page
Warning This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Before you install, operate, or service the system, see the Regulatory Compliance and Safety Information
Note
for the Cisco MDS 9000 Family for important safety information.
To install the Cisco MDS 9509 Director on top of the shelf brackets, follow these steps:
Step 1 Verify that the shelf brackets are level and securely attached to the rack-mounting rails, and the rack is
stabilized.
Slide the Cisco MDS 9509 Director onto the shelf brackets, ensuring it is squarely positioned.
Step 2
Attach the Cisco MDS 9509 Director to the rack-mounting rails. Slide the clip nuts over the holes on the
Step 3
nonthreaded rails on the cabinet or rack. These clip nuts provide the threading for the screws that will
secure the chassis to the cabinet or rack. Use the 10-32 x 1/2 inch screws provided in this shelf bracket
kit to secure the chassis to the cabinet or rack. See
on page
Caution
Cisco MDS 9500 Series Hardware Installation Guide
B-16
2-6.
2-6.
We recommend grounding the chassis, although the rack is already grounded. There is a
grounding pad with two threaded M4 holes on the chassis for attaching a grounding lug.
Appendix B
"Installing the Chassis in a Cabinet or Rack" section
"Installing the Chassis in a Cabinet or Rack" section
Cabinet and Rack Installation
OL-19587-01