Cisco MDS 9500 Series Hardware Installation Manual page 93

Chapter 2 Installing the Cisco MDS 9500 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 2-5
1 Side rack-mount bracket
Step 3 Attach the crossbar to the back of the side rack-mount brackets using one M3 x 8-mm screw per side as
shown in
Figure 2-6
3
1 Side rack-mount bracket
2 Side rack-mount bracket
Step 4 Position a person at each side of the chassis. Grasp the chassis handle with one hand and use the other
hand near the back of the chassis for balance. Slowly lift the chassis in unison, avoiding sudden twists
or moves to prevent injury. Place the rear of the chassis on the side rack-mount brackets between the
front mounting rails, and slide it until it rests on the crossbar and the side rack-mount brackets (see
Figure
OL-19587-01
Installing the Side Rack-Mount Brackets for the Cisco MDS 9509 Chassis
1
Figure 2-6.
Attaching the Crossbar to the Side Rack-Mount Brackets (Rear View)
1
4
2-7).
2 1
2 Screws, 12-24 or 10-32
Front of rack
2
3
3 Screws, M3
4 Crossbar
Cisco MDS 9500 Series Hardware Installation Guide
Installing the Chassis in a Cabinet or Rack
2-13