Leds On The Mps-14/2 Module - Cisco MDS 9500 Series Hardware Installation Manual

Services Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 1-29
Figure 1-29
1 Status LED
2 1-Gbps/2-Gbps Fibre Channel ports
3 Link LEDs (under ports, on left) and Speed LEDs

LEDs on the MPS-14/2 Module

Table 1-16
Table 1-16
LED
Status Green
Speed On
Cisco MDS 9500 Series Hardware Installation Guide
1-46
shows an MPS-14/2 module.
Cisco MDS 9000 Family MPS-14/2 Module
1 2 3 4 5 6
STATUS
LINK— —SPEED LINK—
1
(under the ports, on the right)
describes the LEDs for the MPS-14/2 modules.
LEDs for the Cisco MDS 9000 Family MPS-14/2 Modules
Status Description
All diagnostics pass. The module is operational (normal initialization sequence).
Orange One of the following occurs or occurred:
• The module is booting or running diagnostics (normal initialization sequence).
• The inlet air temperature of the system exceeded the maximum system
operating temperature limit (a minor environmental warning). To ensure
maximum product life, you should immediately correct the environmental
temperature and restore the system to normal operation.
Red One of the following occurred:
• The diagnostic test failed. The module is not operational because a fault
occurred during the initialization sequence.
• he inlet air temperature of the system exceeded the safe operating temperature
T
limits of the card (a major environmental warning). The card shut down to
prevent permanent damage.
2-Gbps mode.
Off 1-Gbps mode.
2
7 8 9 10 11 12 13 14
—SPEED LINK—
3
4 Gigabit Ethernet ports
5 Link LEDs
6 Asset tag
Chapter 1
4
1 2
LINK- LINK-
GIGABIT E THERNET
—SPEED
5 6
Product Overview
OL-19587-01