Preinstallation; Installation Options - Cisco MDS 9500 Series Hardware Installation Manual

Preinstallation

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement
Warning
1022
Preinstallation
This section provides the following topics:
•
•
•
•

Installation Options

The Cisco MDS 9513 Director can be installed using the following methods:
•
The Cisco MDS 9509 Director can be installed using the following methods:
•
•
•
•
The Cisco MDS 9506 Director can be installed using the following methods:
•
•
Cisco MDS 9500 Series Hardware Installation Guide
2-2
Installation Options, page 2-2
Installation Guidelines, page 2-3
Required Equipment, page 2-5
Unpacking and Inspecting the Switch, page 2-5
In an open four-post EIA rack, using:
The rack-mount kit shipped with the switch
–
In an open EIA rack, using:
– The rack-mount kit shipped with the switch
– The telco and EIA Shelf Bracket Kit (optional and purchased separately) in addition to the
rack-mount kit shipped with the switch
In a perforated or solid-walled EIA cabinet, using:
– The rack-mount kit shipped with the switch
– The telco and EIA Shelf Bracket Kit (optional and purchased separately) in addition to the
rack-mount kit shipped with the switch
In a two-post telco rack using the rack-mount kit shipped with the switch
In a four-post nonthreaded cabinet or rack using the optional 9500 Shelf Bracket Kit
In an open EIA rack, using:
The rack-mount kit shipped with the switch
–
The telco and EIA Shelf Bracket Kit (optional and purchased separately) in addition to the
–
rack-mount kit shipped with the switch
In a perforated or solid-walled EIA cabinet, using:
The rack-mount kit shipped with the switch
–
Chapter 2 Installing the Cisco MDS 9500 Series
OL-19587-01