Installing A Front Fan Module On The Cisco Mds 9513 Director - Cisco MDS 9500 Series Hardware Installation Manual

Removing and Installing Fan Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 2-37
When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let the
Warning
fan blades completely stop before you remove the fan tray. Statement 258

Installing a Front Fan Module on the Cisco MDS 9513 Director

To install a front fan module on the Cisco MDS 9513 Director, follow these steps:
Hold the fan module so that the Fan Status LED is at the top. (See
Step 1
Step 2 Place the fan module into the front chassis cavity so it rests on the chassis, lift the fan module up slightly
to align the top and bottom chassis guides, then push the fan module into the chassis until it seats in the
backplane and the captive screws make contact with the chassis. The fan module will just snap in.
Step 3 If the switch is powered on, listen for the fans; you should immediately hear them operating. If you do
not hear them, ensure that the fan module is inserted completely in the chassis and the outside surface
of the fan module is flush with the outside surface of the chassis.
Verify that the Fan Status LED is green. If the LED is not green, one or more fans are faulty. If this
Step 4
occurs, contact your customer service representative for a replacement part.
Cisco MDS 9500 Series Hardware Installation Guide
2-70
Removing the Fan Module for the Cisco MDS 9513 Director
Chapter 2 Installing the Cisco MDS 9500 Series
Figure 2-39.)
OL-19587-01