Advertisement
'IMI 66-047
The system can be defaulted to a standard class of service per the
following procedure.
beginning of each COS programming procedure and shaded on the
programming reference charts.
1
Press
ITCM * 7
2 Press program key C38
3
Press keypad key(s) to choose default settings
1 = system COS default
2 = line COS default
station COS default
= One 80 column SMDR line 8 = Two 40 column SMDK lines
RECALL = Tape baud rate of 100
SAVE
= Tape baud rate of 50
7051684 = master default (CAUTION: resets all values
and clears all stored meinory
while system is in use)
4 Press *
MONITOR
Several different telephone and console overlays are packed with the
system.
The overlay to be used is dependent upon the particular
models of equipment connected to the programming station port (10 or
11) and the respective console port (loa or lla).
overlays are illustrated in Figure 3-l.
overlays are also included at the end of this chapter.
copies can be removed and prepared for use if needed.
CLASS OF SERVICE DEFAULT
The default conditions are listed at the
4 6 *
4 = pulse dialing - all lines
5 = tone dialing - all lines
6 = flexible key/function default
The programming
Full-scale copies of the
The full-scale
Programming
Advertisement
