Advertisement
Several programming steps under COS programming must be observed
proper operation of a Single-Line Keyset.
@When the system is strapped for key system configuration, the
Single-Line Keyset is an intercom only station.
configured for private line only by programming the applicable
station port for the prime line automatic feature.
programmed with the prime line automatic feature, the Single-Line
configuration,
one or more lines must be programmed into a line group.
transferred to the single-line station.
preference feature with ringing enabled on all desired lines.
Alternately it can be programmed to have the prime line automatic
feature with ringing enabled at the prime line.
The first step in any COS programming sequence is to enter the base
level programming mode from station port
COS can be set as desired.
To
enter base level:
1 .
Press the
Press the following keys in sequence: * 7 4 6
2 .
that the base level programming mode is entered.
3 .
Press the *
that the base level mode is active.
4 .
Proceed from this point to program the system, line, or station
COS and the toll restriction tables.
SPECIAL PROGRAMMING REaUIREfqENTS
FOR SINGLE-LINE KEYSETS
to originate outside calls with a Single-Line
BASE LEVEL PROGRAM ENTRY MODE
ITCM
key.
The dial tone will sound.
key.
The dial tone will return as a confirmation
It can be
When the port is
the Single-Line
Otherwise,
10
Once in this mode,
or 11.
Advertisement
