Advertisement
IMI 66-647
CONSIDERATIONS
any sturdy, flat, surface.
desired.
The power supply cabinet can be mounted so that the power
connector and fuses are facing either toward the right side or
toward the left side of the mounting location.
cabinets with respect to each other so that this cable will reach
between the cabinet connectors.
than within six inches of each other.
electrical outlet.
AMP circuit, with a third-wire ground, supplied to a NEMA 5-15R
electrical outlet.
l
The distance between the KSU and the TELCO/PBX
or less as per FCC requirements.
recommended.
ventilation.
degrees F (O-5U degrees C), and
less than 90 percent non-condensing.
material, a backboard must
used for
KSU
commercially or can be constructed
size.
Tools and hardware required for mounting the KSU cabinet include:
@Fasteners
or wall anchors
*Screwdriver
@Electric drill - if prepared holes are required
b l o c k .
@Crimping tool - for 623-type modular plugs
1.
Unpack, and carefully inspect the KSU, power supply, and stations
for shipping damage.
damages found.
accessories needed for proper installation and operation.
2 .
If a backboard is required at the mounting location, attach it
securely to provide
CHAPTER 2
INSTALLATION
They may be vertically rack mounted if
located within six (6) feet of a proper
must be
The power supply requires a dedicated 117VAC 15
must be
The temperature range of the location must x e within
be
mounting.
Suitable mounting backboards are
tool - for fastening wires to a type-66 connector
Notify the shipper immediately of any
Verify that the packages contain all parts and
a stable
attached vertically to
be
Do not locate the cabinets closer
A nominal distance of 7 feet is
secure and dry and.have
the
attached to the mounting surface to be
of l/2-inch plywood cut to
out
mounting surface for the equipment.
2-l
Installation
Locate the
jacks must be 25
a d e u a t e
relative
humidity must be
available
feet
bolts,
Advertisement
