Advertisement
IMI 66-047
Key System/Multifunction jHybrlLd_r
The system can be configured to operate as either a key system or as a
multifunction (hybrid) system.
Configuration is by way of a wire strap placed between clip terminals
27 and 28 of station connector block J-4.
The KSU is shipped from the factory as a key system (KF).
operation over to the multifunction
The KF and MF designations are equipment type catagories as stipulated
in FCC rules and regulations, Part 68, and appear as part of the FCC
Registration Number on the equipment label.
registration number must be reported to the telephone company at the
time of connection along with other FCC mandated information. (Refer
to Installer/User Information Regarding FCC Rules and Regulations
------------ e-.---;---v.-
found in Chapter 1 of this manual.)
Operationally,
the multifunction (hybrid) configuration enables a PBX
feature which may incur a higher monthly tariff to the telephone
company.
This feature allows dial access to (automatic selection of)
outgoing lines.
multifunction (hybrid) configuration is:
l
Line Group (Including Dial Access)
Music Interface
If music is to be part of the system, connect a KX registered music
source to the KSU input jack (phono jack) provided for this purpose.
The impedance of this input is approximately 500 ohms.
adjustment of the music source may be necessary.
during system checkout.
Cassette Tax Recorder Interface
------
A customer provided, audio cassette, tape recorder can be connected to
the music interface jack.
stored and loaded via the recorder through this interface.
action is controlled from station 10 as detailed in Chapter 3, System
Programming.
-- _____ -_._ ----- .--.- .-- ---.-
The specific Executech feature that is enabled by the
Class of service programming can be both
system, add the strap.
(MF)
The appropriate
2-8
Installation
To convert
Level
This may be done
This
Advertisement
