Advertisement
IMI 65-047
3 .
Full scale mounting templates are supplied in the packing boxes.
Hold or tape them to the mounting
of the mounting holes on the mounting surface as they are located
on the templates.
locations are shown on Figure 2-l.
4 .
Drill holes in the mounting surface of a proper size to
accommodate the hardware being used.
holes with inserts, anchors or other attachment devices as
dictated by the type of mounting surface.
Attach the KSU and power supply cabinets to the mounting surface
with four (4) screws installed through the KSU mounting flange and
into the mounting surface holes.
elongated with an enlargement at one end.
mounting screws to be partially installed in the mounting surface
before the cabinets are hung on them.
power supply cabinet have an enlargement at the center of the
elongated holes to allow the cabinet to be mounted with the power
connector and fuses facing either toward the right side or toward
the left side of the mounting location.
Place the individual telephone stations as desired and in keeping
with accepted industry and office standards.
can
wall mounted if necessary as they are desk/wall reversible.
be
Refer to Chapter 4, Naintenance,
desk/wall reversible station for wall mounting.
The mounting dimensions and general equipment
Figure 2-1.
Mounting
and mark the location
surface,
If necessary, prepare these
Note that the flange holes are
This feature allows the
The flange holes on the
A telephone station
for instructions in preparing a
Dimensions'
Installation
Advertisement
