Voxelab Aquila C2 User Manual page 24

Start printing
开始打印
Print
打印
Note: Notice the distance between the nozzle and the build plate during printing the first layer. If the distance is improper, please press knob, and select [Tune] -
[Babystep Z] to perform the Z-axis offset.
注意：当打印第一层时若发现喷头与平台之间的距离不合适时，请按压旋钮，选中【Tune】-【Babystep Z】进行Z轴补偿。
When the offset value is positive, the nozzle and the build plate get farther; when the offset value is negative, the nozzle and the build plate get closer.
当补偿值为正时，喷头与平台间隙变大；当补偿值为负时，喷头与平台的间隙变小。
Note: Do not unplug the screen cable during printing.
打印过程中请勿插拔显示屏。
23