2F24】Cutter Shift Timeout Error - Canon iPF9000S Troubleshooting Manual

11. 【2F24】Cutter shift timeout error
Occurrence
The cutter wont' move to the home position or the position opposite to the home position in
condition
time.
C1 Cannot cut sheet
Faulty cutter drive
C2
unit
Faulty cutter
C3
electrical equipment
Cause
C1, C2, C3 Check the cutter position at an error stop.
C1, C2, C3 iPF5000/iPF800 Series
C1, C2, C3 iPF700/iPF8000 Series
Flow 1
iPF5000/iPF800 Series
Cutter positioned
Is the motor rotating?
at the left end
Remove foreign matter
from the sensor if any
Check the
Cutter positioned
right-side
at the right end
sensor visually
Cutter anywhere
If non-recommended paper has
other than the left
been used, check with a
and right ends
recommended paper equivalent
Cutter Motor Drive Voltage Check
Evaluation method
The drive voltage is normal if the voltage
appears to vary by a margin of several volts
while the cutter is driven.
Worn cutter
Special paper
Worn/broken drive gear (iPF5000 Series)
Faulty cutter motor (iPF5000 Series)
Carriage malfunction (iPF700, iPF8000 Series)
Bitten wires (iPF5000 Series)
Faulty sensor
Faulty cutter driver PCB (iPF5000, iPF500, iPF600 only)
Faulty main controller (iPF5000 Series)
Yes
No
Is the drive voltage
Check for bitten
wires available (*) ?
*See "Cutter Motor Drive Voltage Check" for the subsequent action to take.
-Check for bitten wires
-Check for successful
No foreign
operation in IO mode
matter
Remove the foreign matter
Foreign matter
present
Chapter 3 More Sophisticated Fault Isolation Tasks
Point to check
Check the gear/belt
For the iPF5000, iPF500 and
iPF600 only
No
Replace the cutter driver
Yes
Replace the motor
A sensor fault has been
identified by replacing with
a lift detection sensor
Replace the cuter driver
For the iPF5000, iPF500 and iPF600 only
Replace with recommended paper
Replace the cutter
Cutter
Cutter lift motor
Cutter HP sensor
Cutter lift sensor
3-18
Action
Flow 1
Flow 2
Replace the main
controller
Replace the sensor
Replace the main
controller
Cutter motor
Cutter right position sensor