Canon iPF9000S Troubleshooting Manual page 53

Panel display
Code
(last 4
Large LCD
digits)
2E1C Paper jam.
Press Load/Eject
and reload the
paper.
2E1D Cannot load.
Press Load/Eject
and reload the
paper.
2E1F Cannot print
as specified.
Press Load/Eject
and replace paper
with A2/16.6"x23.4"
(vertical) or larger
Cannot print as
specified. Press
Load/Eject and
replace roll with 10
in. wide or larger
roll.
Cannot print as
specified. Lift the
release lever and
replace paper with
[ XXX ] (vertical) or
larger.
Cannot print
as specified.
Lift the release
lever and replace
roll with 10 in.
wide or larger roll
Cannot print
as specified.
Replace paper with
[XXX] (vertical)
or larger.
The paper is too
small. Replace
paper
with [XXX] (vertical)
or larger.
The paper is too
small. Replace roll
with 10 in. wide or
larger roll.
Cannot print as
specified. Lift the
release lever and
replace paper with
[XXX] (vertical) or
larger.
Cannot print as
specified. Lift the
release lever and
replace roll with 10
in. wide or larger roll.
Small LCD
Paper Jam Jam while ejecting paper
Press ↑ Key
(A sequence of removing jams with the
pinch roller released is required)
A jam has been detected while ejecting
paper.
Remove paper Feeding error
Cannot Feed LF out of synchronization for cut sheet
Press ↑ Key
Paper Mismatch Paper mismatch (size)
ReplcPap:Press↓ The second and subsequent sheets of
paper have been fed as a paper size
different from the first sheet when
adjustment was made with cut sheet.
The paper size setting in effect at the start of
Need A3 Vertical
an internal print session has fallen below the
or Larger
minimum size specified for that internal print
Press ↓ Key
session.
and Reload
[XXX x YYY]: Required minimum size
The second and subsequent sheets of paper
have been fed as a paper size different from
the first sheet when adjustment was made
with cut sheet.
［XXX x YYY］: Required minimum size
Explanation/Detection sequence
2-41
Chapter 2 Indexes by Case
Remedial Action
(★: Reference fault
isolation procedure
or tool)
①Open and
close the
release lever to
reload the
paper.
②Remove the
paper once and
then refeed it.
★Go to
2E27(P3-14).
①Refeed the
paper.
★Go to
2E27(P3-14).
Check the paper
that is actually
loaded on the
printer and the
paper size setting
of the driver.
Go to ★2010
(P3-12).