Canon iPF9000S Troubleshooting Manual page 25

Panel display
Code
(last 4
Large LCD
digits)
200D Paper size not
detected.
Press Load/Eject
and reload the
paper.
Leading edge
detection error.
Lift the release
lever and align
leading edge
with orange line.
Paper size not
detected.
Lift the release
lever and reload
the paper.
Paper size not
detected.
Reload paper.
200E This paper
cannot be used.
Check supported
paper sizes.
This paper
cannot be used.
Check supported
paper sizes.
Load/Eject: Change
Paper
Small LCD
Paper Paper size detection failure
Please Reload Cannot detect the trailing edge of the paper.
・Cannot detect the trailing edge of the cut
Size Undetected
Press ↑ Key
・Cannot locate the trailing edge of the paper
Paper Size Paper is too small
Please Check The width and length of paper detected are
Paper Too Small shorter than the supported size (1.5%
Press ↑ Key
margin).
Paper Size
Please Check
Paper Too Small
Press Online Key
Explanation/Detection sequence
sheet loaded after they have been fed 50
mm.
that has been found by coarse detection.
2-13
Chapter 2 Indexes by Case
Remedial Action
(★: Reference fault
isolation procedure
or tool)
①Check to see if
roll paper are
not loaded in
the cut sheet
mode.
②Load cut
sheet. Go to
★2010
(P3-12)
①Check paper
conditions
(soiling,
tear-offs,
residual paper
chips, residual
trimming cuts,
folds)/size.
②Has the paper
been fed
successfully
(without
slippage under
a load or any
influence)?
③Has the LF
adjustment
value set
correctly?
④Hasn't the
loaded paper
shrunk to
below its
margin in the
particular
environment?
Go to ★
2017/2018 (P3-12)