Canon iPF9000S Troubleshooting Manual page 74

Panel display
Code
(last 4
Large LCD
digits)
404C ERROR
E196-404C
Call for service.
404D ERROR
E196-404D
Call for service.
404E ERROR E196-404E
Call for service.
404F ERROR E144-404F
Call for service.
4050 Error E161-4050
Call for service. For
iPF6000,
03800500-4050.
405A Error E602-405A
Call for service.
405B Error E602-405B
Call for service.
！The paper loaded
4061
askew. Remove the
paper.
Small LCD
ERROR
E196-404C
Call For Service
ERROR
E196-404D
Call For Service
ERROR An EEPROM read/ write error has been
E196-404E detected in the controller portion of the
Call for service. firmware.
Pump revolutions full
The number of HP pre-ejection pump
revolution has reached the defined value.
Non-ejection detection error
Error!
The timing of "ink priming sequence" is
E161-4050
fallowing.
Call for service.
Incorrect capacity HDD model is connected.
Mismatched HDD model is connected.
Postion ditection of askew loaded paper.
Explanation/Detection sequence
Serial number information mismatch
A mismatch has been detected between the
serial number information stored in the
EEPROM on the main PCB and that stored
in the EEPROM on the MTC relay PCB at
startup.
Machine ID information mismatch
A mismatch has been detected between the
model ID information stored in the EEPROM
on the main PCB and that stored in the
EEPROM on the MTC relay PCB at startup.
・at installation of a new model printer
・At reinstallation after the second
transportation.
・At replacement of the printhead
2-62
Chapter 2 Indexes by Case
Remedial Action
(★: Reference fault
isolation procedure
or tool)
①Check to see if
the correct
PCB is
mounted,
since a PCB of
the wrong
model may
have been
mistakenly
mounted
during
servicing.
②Invoke service
mode to
implement
PCB
replacement.
①Check to see if
the correct
PCB is
mounted,
since a PCB of
the wrong
model may
have been
mistakenly
mounted
during
servicing.
②Invoke service
mode to
implement
PCB
replacement.
①Start in
download mode
to upgrade the
firmware.
②Start in service
mode to clear
the error.
③Replace the
main PCB.
①Clear the
counter in
service mode
after having
replaced the HP
pre-ejection tray
unit.
Go to ★
2F2F/2F30 (P3-5)
Refer to 2F2F for
the prior error
detection.
Replace HDD
Replace HDD
Go to ★2010.
(P3-12)