Canon iPF9000S Troubleshooting Manual page 44

Code Panel display
(last 4
Large LCD
digits)
282A CR MOTOR TUNING
ERROR :PRESS OK
282B CR VIBRATION
ERROR :PRESS OK
282D Left printhead
error.
Turn off printer,
wait, then
turn on again.
！Printhead error
282E
Turn off printer,
wait, then
turn on again.
2830 Left printhead
error.
Open top cover and
replace the left
printhead.
Hardware error
2832
03130031-2832
Turn off printer,
wait, then
turn on again.
Hardware error
2833
03130031-2833
Turn off printer,
wait, then
turn on again.
！Unknown printhead.
2834
Open top cover and
re-install printhead.
2901 Mail box
nearly full.
Delete unwanted data
The mail box is
nearly full. Delete
unwanted jobs.
2902 Mail box full.
Now printing
without saving data.
Explanation/Detection sequence
Small LCD
Carriage motor identification processing
(rotation adjustment) failed (for Service
mode)
When processing carriage motor
identification (rotation adjustment),
carriage vibration has been detected
(for Service mode).
Printhead error detected (L head only).
Displayed when an abnormal
temperature rise of printhead has been
detected to prompt you to restart.
Temperature
particular
printing was judged abnormal.
Printhead error detected (L head only).
Displayed when restarting after
detection of error 282D to prompt you to
replace printhead L.
VHT leak detection error of right
printhead or of a single printhead, in
case of VHT exceeds rated value or
falls below the rated value.
VHT leak detection error of left
printhead, in case of VHT exceeds rated
value or falls below the rated value.
Printhead contact failure is detected
after the
printhead installation.
The available size of the permanent
area of the hard disk space has fallen
to less than 1 GB.
The hard disk has run out of free
space, disabling copy printing or error
recovery.
2-32
Chapter 2 Indexes by Case
rising detected by
ink pre-injection before
Remedial Action
(★: Reference fault
isolation procedure or tool)
Error is cleared by OK
button.
①Check installation of
carriage or carriage
belt.
②Clean the carriage
main rail (Do not oil
it.)
③Replace the carriage
motor.
Error is cleared by OK
button.
①Check installation of
carriage or carriage
belt.
②Clean the carriage
main rail (Do not oil
it.)
③Replace the carriage
motor.
After restarting, replace
the printhead L.
① Replace the
printhead.
② Replace the main
board.
Replace the printhead
L.
iPF6300/6400 Series
iPF8300/8400/9400
Series
Replace right or left
printhead.
①Remove and reinstall
the printhead.
②Replace the
printhead.
③Replace the CR unit.
④Replace the main
board.
Reorganize data.
Reorganize data.