Table of Contents
Advertisement
®
1.
Clean mating surfaces and apply a bead of silicone
sealant to the face of the hub that mates with the ring
gear (item 4). See instructions on sealant package.
2.
Place the gear of primary carrier assembly (item
2) into secondary carrier assembly, and place both
assembly into ring gear (item 4) while aligning gear
teeth.
3.
Place sun gear (item 1) into primary carrier assembly
(item 2). Sun gear should turn freely by hand.
4.
Apply a bead of silicone sealant to cover face of ring
gear (item 4).
5.
Secure thrust washer (item 6) with tangs engaged
in cover (item 5).
NOTE: Washer can be secured to cover with a small
amount of grease or silicone sealant. Install the cover
and align with hub such that pipe plug holes on cover
align with mounting holes on hub.
6.
Install washers and capscrews (not shown) and
torque to 40-45 lb. ft. (54-61 Nm) with dry threads.
Lubed threads torque to 20-25 lb. ft (27-34 Nm).
7.
Position filler opening horizontally and fill unit to oil
level hole in cover. Install fittings (items 7, 8 & 9) in
cover (item 5).
Section 4
4 - 27
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the H6H and is the answer not in the manual?