A P P E N D I X A Wide Area Virtualization Engine Hardware Specifications; Appliance Specifications - Cisco Wide Area Virtualization Engine 274 Hardware Installation Manual

Appendix A Wide Area Virtualization Engine Hardware Specifications
Table A-1 WAVE-274 and WAVE-474 Features and Specifications (continued)
Specification
Environment
1
Acoustical noise emissions
3
Heat Output
1. These levels were measured in controlled acoustical environments according to the procedures specified by the American
National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 9296. Actual
sound-pressure levels in a given location might exceed the average values stated because of room reflections and other nearby
noise sources. The declared sound-power levels indicate an upper limit, below which a large number of computers will
operate.
2. In acoustics, the logarithm of the ratio of a quantity to a reference quantity of the same kind is called a level. The base of the
logarithm (always ten, unless otherwise specified), the reference quantity, and the kind of level shall be specified. bel is a unit
of level when the base of the logarithm is ten, and the quantities concerned are proportional to power.
3. Power consumption and heat output vary depending on the number and type of optional features installed and the
power-management optional features in use.
4. BTU = British Thermal Unit.
OL-17739-01
Description
Air temperature:
•
Device on: 50 to 104° F (10 to 40° C); altitude: 0 to 2000 m
–
(6500 ft)
Device off: –22 to 140° F (–30 to 60° C); maximum altitude:
–
9144 m (30000 ft)
Humidity
•
Device on: 20 to 80% (noncondensing at ambient)
–
Device off: 5 to 90% (noncondensing at ambient)
–
Declared sound power, idle: 3.8 bel
•
• Declared sound power, operating: 4.9 bel
Minimum configuration: 1230 Btu
•
Maximum configuration: 3390 Btu (835 watts)
•
Cisco Wide Area Virtualization Engine 274 and 474 Hardware Installation Guide

Appliance Specifications

2
4
(360 watts)
A-3