Post Numeric Codes And Text Messages - Cisco Wide Area Virtualization Engine 274 Hardware Installation Manual

Chapter 5 Troubleshooting the System Hardware
Note

POST Numeric Codes and Text Messages

Note
Table 5-10 Diagnostic Front Panel LEDs and Beep Codes
Control Panel Message
101-Option ROM Checksum Error
103-System Board Failure
110-Out of Memory Space for Option ROMs
162-System Options Not Set
163-Time & Date Not Set
163-Time & Date Not Set
164-Memory Size Error
164-Memory Size Error
OL-17739-01
A single problem might cause several error messages. When this situation occurs,
you should correct the cause of the first error message. After you correct the cause
of the first error message, the other error messages usually will not occur the next
time that you run the test.
This section covers POST errors that have numeric codes associated with them.
The section also includes some text messages that may be encountered during
POST.
The computer will beep once after a POST text message is displayed on the
screen.
Cisco Wide Area Virtualization Engine 274 and 474 Hardware Installation Guide
Description
System ROM or expansion board option ROM
checksum.
DMA or timers.
Recently added PCI expansion card contains an
option ROM too large to download during POST.
Configuration incorrect.
RTC (real-time clock) battery may need to be
replaced.
Invalid time or date in configuration memory.
The RTC (real-time clock) battery may need to be
replaced.
CMOS jumper may not be properly installed.
Memory amount has changed since the last boot
(memory added or removed).
Memory configuration incorrect.
Power-On Self Test (POST)
5-13