Safety - Pfannenberg EB Series Operating And Maintenance Instructions Manual

EN

2. Safety

The chiller instructions must be read by the installer and personnel in charge for operation, before starting the
chiller.
All safety and security instructions given in this manual must be observed!
Only qualified personnel are allowed to install, operate and do the maintenance work.
Non-observance of the instructions may cause injuries and will cancel the manufacturer's liability for subsequent
damage.
National regulations on accident prevention, regulations of the local power supply authorities as well as any specific
safety instructions for chiller must be observed.
The safety of the unit is only guaranteed, if it is used as intended.
The following points must be observed before commissioning and while operating the chiller:
Familiarize yourself with all operating controls.
Make sure that all working limits indicated within unit label are observed.
Use protective devices to check electrical insulation. Do not carry out any work on any part of the equipment that
are live with wet clothing, hands and feet.
Never spill or pour any cooling medium into the environment as this may cause health hazard.
The components of the chiller must not be modified in any way.
Disconnect the power supply and release pressure from any pressurized component before carrying out any
service work on the Chiller.
A qualified commissioning engineer must ensure that the chiller has been connected to the electrical mains in
accordance with the standard EN 60204 and all other applicable national regulations.
It is also mandatory to comply with Regulation (EU) No 517/2014 of the European Parliament and of the Council of
16 April 2014 on certain fluorinated greenhouse gases.
The above mentioned Regulation lays down specific measures and restrictions to be considered while
commissioning, operating, maintaining and disposing any equipment containing greenhouse gases, such as HFCs,
as specified in Annex I. It also specifies mandatory leakage-check frequency to be performed by certified personnel
and mandatory records providing the evidence of exact fluorinated gas charge and subsequent added and/or
recovered quantities (e.g. Article 3).
CAUTION
Compliance with legal requirements
In accordance to the F-GAS regulation (EU) No 517/2014, every year the operator (the owner of the equipment)
is responsible to ensure a gas leakage test, the recording of the gas quantity change inside the unit and the
communication to the responsible agency of the state in the European community where the unit is in
operation.
If you need any consultancy in terms of a maintenance and leakage check according (EU) No. 517/2014 please
contact our Pfannenberg Service Team (see chapter Contact).
WARNING
Spare parts from third-party manufacturers can damage the unit
Only original parts are subject to the manufacturer's quality control.
Only use specially agreed harmonized manufacturer parts for safe and reliable operation.
•
For Pfannenberg spare part numbers, see supplied document
If you have questions about spare parts, please contact our Pfannenberg Service Team (see chapter Contact).
Operating and Maintenance Instructions - Chiller - Series EB 210 - EB 440
Spare part list (part of the delivery)
© Pfannenberg GmbH Page 56 / 293