Saving And Adjustment Process - Televes Avant 5 Manual

User instructions
Saving and Adjustment process. (Programming unit PCT 4.0)
Press for more than three seconds from any of the menus/submenus and the saving and adjustment process will
begin. The display will indicate the following information:
- Saving the configuration in EEPROM
- Starting the adjustment
- Configuration of the inputs
- Previous scan (switch on of the powerings and automatic adjustment of the input attenuators)
- UHF adjustment
- Adjustment of each filter (with interaction of the user in the case of error)
- VHF adjustment (in the case it is not cut-off)
- FM adjustment (in the case it is not cut-off)
- Output attenuator adjustment
- Adjustment of the highest channel programmed to a specific output level
The errors regarding a high or low level are indicated by messages on the display.
The adjustment can be attempted again by pressing the
quickly.
Examples:
Programming
and saving
parameters
...
Adjusting
filter: 1
...
Filter: 1
Input signal
LOW LEVEL
Skipping
filter: 1
...
F1- F2 F3-
F4ø F5ø F6-
F7ø F8ø F9ø
F0ø VHFø FMø
Begining of the saving and adjusting secuence
Long press of the button
Adjusting UHF filters.
Adjusting filter 1.
Adjusting UHF filters.
Low level input signal.
Adjusting UHF filters.
Ignoring adjustment of filter 1 by short pressing on the
Final result of the adjustment
button quickly or ignored by pressing the
button.
50 50
"Avant 5"
button