Using The Unit. Universal Programming Unit Pct 4.0; Using The Programming Unit - Televes Avant 5 Manual

User instructions

Using the unit. Universal Programming Unit PCT 4.0

Using the programming unit

This system is programmed by the Universal Programmer PCT 4.0. The programming unit has a menu with various
options which the user can scroll through by pressing the
- Configuration of the system's UHF inputs (number of filters per input).
- Switching off of the VHF and/or FM inputs.
- Select the channels for each filter (maximum 5 consecutive channels per filter).
- Set the UHF output level (it determines the VHF and FM levels).
- Set the UHF equalisation slope.
- Set the IF configuration.
The buttons and LEDs indicate the following:
LEDs
A : Indicates "Main Menu" mode.
B : Indicates "Extended Menu" mode.
C : Indicates "Saving" mode.
Buttons
: Menu or submenu options.
: (short press) - To change the submenu options.
: (long press) - To change from the main menu to the extended menu.
: (short press) - To scroll through the main menus.
: (long press) - To save and adjust (from any menu or submenu).
+ + : Increases the contrast of the screen.
+ + : Decreases the contrast of the screen.
Once connected, the programmer receives the previously set parameters from the Avant unit (memorised channel in
each cluster, input configuration, output level . . .).
The programming unit begins by accessing the "UHF config." menu so that by pressing the menu selection button
, we can scroll through the different options and with the
Once all of the system's options have been selected, press the adjustment button
the Avant's green adjustment LED on) and the unit automatically records and sets up all the parameters selected with
the programming unit.
NOTE: To carry out the level adjustment process, it is necessary to terminate the two outputs of the unit with a
75 ohms impedance (ref. 4061), without needing to load the unused inputs, see fig. 1.b (page 62).
The adjustment button
is.
PCT 4.0
firmware
------------
Version 4.01
can be pressed (long press) at any time independently of the option of the menu the Avant
button and which allow the following functions:
Unit
firmware
------------
Version 2.00
buttons we can select the desired parameters.
37 37
"Avant 5"
for a long time (this switches