Table of Contents
Advertisement
Available languages
Available languages
User instructions
2.- FILTER CONFIGURATION menu
The next menu is Filter configuration:
- Allow to program a channel in the selected position. During the manual adjustment (Offset) these buttons allow
to increase or decrease the level of the filter one dB per press.
- (short press) - Moves the cursor to the next position within the filter (5 in total) or to the manual adjustment
position (Offset).
- (long press) - Enters the extended menu.
- (short press) - Changes to the next filter (next main menu)
- (long press) - Saving and adjustment
Procedure
If there are no channels assigned to the filters, the menu will be shown empty.
To assign a channel to one filter, press
channel between C21 and C69. The selected channel can be either analogue "A" or digital "D".
FILTER 1
-- -- --
-- --
Offset: --
You can include up to 5 channels per filter. In this case the channels must be consecutive.
Once all the filters have been configured, select the output level, ... and performing the automatic adjustment of the
Avant, the Offset option will be activated.
This option allows to increase or decrease the level of the selected filter one dB per press (once the automatic
adjusment has been made). The display will blink during the readjusment process (one dB per press). Once the readjust-
ment has finished the reached valued will be shown, informing whether it was possible or not to increase/decrease the
output level. It will not be able to readjust if it goes back to the previous value.
FILTER 1
40D 41A --
-- --
Offset: +0dB
Once the channels of the first filter have been programmed, press the
If you wish to program channels in this filter, proceed as we have just seen for the first filter. Repeat this step to
program all the filters in the Avant.
If you do not wish to program more channels in the filters you have left to program, press the
until you get to the next menu "Output Level Configuration".
Notes:
- The display will show the message ERROR! if you intend to program something illegal (overlapping of filters or
bandwidth of any filter wider than 5 channels). You will not be allowed to leave this menu before solving this
error.
- The manual adjustment (Offset) will be only accessible if the unit has already been adjusted. After the automatic
adjustment the offset will be initialized to 0dB in the filters that are not empty.
to activate the first channel. Then by means of
FILTER 1
21A
-- --
-- --
Offset: --
FILTER 1
40D 41A --
-- --
Offset:
-2dB
40 40
FILTER 1
40D
-- --
-- --
Offset: --
button to enter the next filter.
"Avant 5"
buttons select a
FILTER 1
40D
41A
--
-- --
Offset: --
button repetitively
Advertisement
Chapters
Table of Contents
