Table of Contents
Advertisement
Available languages
Available languages
User instructions
Using the menus - Main Menu
1.- INPUT CONFIGURATION menu
The first menu that appears is "UHF Config" menu:
- Scrolls through the options of the menu.
- (short press) -Places the cursor on each modifiable parameter.
- (long press) - Enters the extended menu.
- (short press) - Changes to the next menu: Filters configuration.
- (long press) - Saving and adjustment.
Procedure
First of all, press the
the desired configuration for the UHF1-UHF2-UHF3 inputs: 9-0-1, 7-2-1, 6-3-1.
UHF Config
U1: 9 - OFF
U2: 0 - OFF
U3: 1 - OFF
Then press the
button to enter the following option of the menu -Inputs powering-. You will be able to select the
input powering mode for each input: Auto, OFF, ON.
ON: Input powering activated.
OFF: Input powering deactivated.
Auto: If there is an amplifier connected and the input signal level is not enough, the Avant will power the amplifier
automatically.
UHF Config
U1: 9 - OFF
U2: 0 - OFF
U3: 1 - OFF
Press
to activate and modify the powering through the other two inputs.
Press
to enter the next menu.
Note:
- In this menu, if the current configuration of the inputs is 9-0-1, the user will not be allowed to modify the
default value (OFF) for the input powering through U2.
button to activate (blinks) the first option -Distribution of inputs-. Use
UHF Config
U1:
9
- OFF
U2:
0
- OFF
U3:
1
- OFF
UHF Config
U1: 9 -
OFF
U2: 0 - OFF
U3: 1 - OFF
UHF Config
U1:
7
- OFF
U2:
2
- OFF
U3:
1
- OFF
UHF Config
U1: 9 -
Auto
U2: 0 - OFF
U3: 1 - OFF
39 39
"Avant 5"
buttons to select
UHF Config
U1:
6
- OFF
U2:
3
- OFF
U3:
1
- OFF
UHF Config
U1: 9 -
ON
U2: 0 - OFF
U3: 1 - OFF
Advertisement
Chapters
Table of Contents
