Connecting E1 Or T1 Pri Telephony Cables With One Multi Access Blade Mp-Ma-16-Pri - Cisco 700 MHz Installation And Upgrade Manual

Chapter 2 Installing the Cisco Unified MeetingPlace 8100 Series Hardware
Connecting E1 or T1 PRI Telephony Cables with One Multi Access Blade
MP-MA-16-PRI
To Connect the E1 or T1 PRI Telephony Cables with One Multi Access Blade MP-MA-16-PRI
Step 1 Locate the following items shipped with the Cisco Unified MeetingPlace Audio Server:
•
•
•
Attach the far end of the first E1 or T1 PRI telephony cable to the equipment that will connect with Cisco
Step 2
Unified MeetingPlace.
In many cases, the other equipment has an RJ-48c socket in which to plug the E1 or T1 PRI telephony
cable. Alternately, the other equipment will be connected to a punchdown block. In this case, you will
need to determine the block's connection diagram and then connect to it with discrete wires from the
cable.
Step 3 Plug the other end of the first E1 or T1 PRI telephony cable into the RJ-45 jack, labeled 1, on the far left
of the front of the breakout box. Continue from left to right as needed. See
Figure 2-13
Repeat
Step 4
Connect the first trunk card cable assembly (50-pin Amphenol cable) to the back of the breakout box by
Step 5
securing the screws on both ends.
Looking at the back of the breakout box, the connector on the right of the breakout box is for spans
1 to 8, and the connector on the left of the breakout box is for spans 9 to 16. Place the first trunk card
cable assembly into the connector on the right. See
Figure 2-14
Step 6 Connect the other end of the first trunk card cable assembly (50-pin Amphenol cable) into the
Multi Access Blade transition module by securing the screws on both ends
For the Cisco Unified MeetingPlace 8106, the connector on the right of the Multi Access Blade transition
module is for spans 1 to 8 and the connector on the left of the Multi Access Blade transition module is
for spans 9 to 16. Place the first trunk card cable assembly into the connector on the right. See
Figure
OL-13417-01
E1 or T1 PRI telephony cables.
Breakout box, which should already be mounted above the Cisco Unified MeetingPlace Audio
Server)
Trunk card interface cable assemblies (50-pin Amphenol cables).
Breakout Box (Front View)
Step 2 and Step 3 until all the E1 or T1 PRI telephony cables are connected to the breakout box.
Breakout Box (Back View)
2-15.
Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 6.x
About Telephony Configurations for E1 and T1 PRI Cisco Unified MeetingPlace Systems
Figure
Figure 2-13.
2-14.
2-19