Connecting E1 Or T1 Pri Telephony Cables With One Multi Access Blade Mp-Ma-4-Pri - Cisco 700 MHz Installation And Upgrade Manual
Audio server
Hide thumbs
Also See for 700 MHz:
- Configuration manual (87 pages) ,
- Administration manual (36 pages) ,
- Getting started manual (27 pages)
Table of Contents
Advertisement
Chapter 2
Installing the Cisco Unified MeetingPlace 8100 Series Hardware
Figure 2-20
Connecting E1 or T1 PRI Telephony Cables with One Multi Access Blade
MP-MA-4-PRI
To Connect E1 or T1 PRI Telephony Cables with One Multi Access Blade MP-MA-4-PRI
Locate the following items that shipped with the Cisco Unified MeetingPlace Audio Server:
Step 1
•
•
•
OL-13417-01
Back of Cisco Unified MeetingPlace 8112 (T1 PRI with 1 MP-MA-16-PRI)
E1 or T1 PRI telephony cables.
Breakout box, which should already be mounted above the Cisco Unified MeetingPlace Audio
Server.
Trunk card interface cable assemblies (50-pin Amphenol cables).
Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 6.x
About Telephony Configurations for E1 and T1 PRI Cisco Unified MeetingPlace Systems
2-23
Advertisement
Table of Contents
Troubleshooting
