Connecting Ip Telephony Cables For Cisco Unified Meetingplace Systems - Cisco 700 MHz Installation And Upgrade Manual
Audio server
Hide thumbs
Also See for 700 MHz:
- Configuration manual (87 pages) ,
- Administration manual (36 pages) ,
- Getting started manual (27 pages)
Table of Contents
Advertisement
About Telephony Configurations for IP Cisco Unified MeetingPlace Systems
Connecting IP Telephony Cables for Cisco Unified MeetingPlace Systems
To Connect IP Telephony Cables for a Cisco Unified MeetingPlace System
Step 1
Locate the IP LAN cables that shipped with the Cisco Unified MeetingPlace Audio Server.
Step 2
Attach the far end of the first IP LAN cable to the RJ-45 socket of the switch or other network equipment.
Step 3
Plug the other end of the first IP LAN cable into the Ethernet 1 connector on the Multi Access Blade.
Step 4
If you have more than one Multi Access Blade in your IP configuration, repeat
Figure 2-21
configuration supports 480 IP ports with one MP-MA-16.
Figure 2-21
Figure 2-22
configuration supports 480 IP ports with one MP-MA-16.
Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 6.x
2-28
shows the connections on the back of the Cisco Unified MeetingPlace 8106. This
Back of Cisco Unified MeetingPlace 8106 (IP with 1 MP-MA-16)
shows the connections on the back of a Cisco Unified MeetingPlace 8112. This
Chapter 2
Installing the Cisco Unified MeetingPlace 8100 Series Hardware
Step 2
and
Step
3.
OL-13417-01
Advertisement
Table of Contents
Troubleshooting
