Installing The Cisco Ts Mse 8710; Step One: Install The Cisco Ts Mse 8710 Blade Into The Mse 8000 - Cisco TelePresence Server MSE 8710 Getting Started

Installing the Cisco
Important:
read the safety information guide for the MSE 8000 chassis at
http://www.cisco.com/go/telepresence/safety.
Although blades are hot-swappable parts, you must only remove one
!
blade at any time. Remove the power from the MSE 8000, if you need to
remove more than one blade at a time.
Before hot-swapping a blade, shut down the blade using the web
!
interface. Do not shut down a blade during a software upgrade or if the
blade is processing (for example, if a conference is taking place on a
Server blade blade).
The MSE 8000 backplane uses high performance data connectors. Do not
!
remove Cisco TS MSE 8710 blades unless absolutely necessary because
doing so may reduce the life of those connectors.
Make sure that you have the correct power requirements and sufficient
!
power in your PSU; for information on powering the MSE 8000 refer to
the Getting Started Guide on
conferencing-documentation.jsp).

Step one: Install the Cisco TS MSE 8710 blade into the MSE 8000

You must install either a blade or a blanking blade in each of the ten
!
positions in the chassis.
1 Remove the blade or blanking blade from the slot into which you are going to
install the Cisco TS MSE 8710:
i Using a No. 1 Phillips screwdriver, loosen the screws in the retaining
latches with an anti-clockwise quarter turn.
TS MSE 8710
Before installing the Cisco TS MSE 8710 into the MSE 8000,
http://www.tandberg.com/support/video-

Installing the Cisco TS MSE 8710

5