Introduction
1
Introduction
The EV2400 EVM interface board enables an IBM-compatible or other type PC (with the required driver
for its particular platform) to communicate with the Texas Instruments SMBus and I
gauges via a Universal Serial Bus (USB) port. In addition to this board, PC software is required to interpret
the gas gauge data to complete the evaluation system.
1.1
Features
•
Fully powered from the USB port
•
Optional 5-V port for powering high-power voltage drivers (future upgrade)
•
Complete interface between the USB and SMBus or I
•
Expansion port for future upgrades
1.2
Kit Contents
•
EV2400 circuit module
•
Standard USB cable
1.3
Ordering Information
2
Interfaces
The EV2400 interfaces are described in the following table. The reference designators on the circuit board
and the functions are also listed.
Reference Designator
Port 1: SMB
Port 2: I2C
Port 3: HDQ
Port 4
Port 5
2
EV2400 EVM Interface Board
Table 1. Ordering Information
EVM Part Number
EV2400
Function
SMBus Interface Port
2
I
C Interface Port
HDQ and DQ Interface Ports
Single Wire Port
GPIO Port
Copyright © 2011–2014, Texas Instruments Incorporated
2
C interfaces using a simple API
Terminal block for connecting to a target
device
Terminal block for connecting to a target
device
Future expansion port
Future expansion port
Future expansion port
SLUU446B – June 2011 – Revised August 2014
Submit Documentation Feedback
www.ti.com
2
C interface gas
Details