Table of Contents
Advertisement
Evaluation Module Overview
1 Evaluation Module Overview
1.1 Introduction
The AM273xEVM is an evaluation module designed to develop software and evaluate the AM273x Radar
Controller and Processor SoC from Texas Instruments. The AM273x is a multicore SoC designed to provide an
integrated control and processing platform for TI AWR mmWave radar front-end devices in both single-device
and cascaded modes of operation. The signal interface between the AM273x EVM and the AWR2243BOOST
mmWave Radar EVM uses the 60-pin Samtec high density connector.
1.2 Preface: Read This First
1.2.1 If You Need Assistance
If you have any feedback or questions, support for Sitara MCUs and the AM273x EVM development kit is
provided by the TI Product Information Center (PIC) and the
can be found on the
TI
website.
1.2.2 Important Usage Notes
A 12V, > 2.5A supply brick with a 2.1mm barrel jack (center positive) is not included in the kit and must
be ordered separately. For more information on power requirements, go to
1.3 Kit Overview
1.3.1 Kit Contents
The Sitara AM273x EVM Development Kit contains the following items:
•
AM273x EVM
•
Micro USB cable
•
Ethernet Cable
•
Samtec coax micro ribbon cable (HQCD-030-02.00-SEU-TBR-1)
•
Spacers, screws, and washers
The maximum length of the IO cables shall not exceed 3 meters.
4
AM273x Evaluation Module
TI E2E
Note
Note
Copyright © 2024 Texas Instruments Incorporated
™
Forum. Contact information for the PIC
Section
2.1.1.
SPRUIY1C – NOVEMBER 2020 – REVISED APRIL 2024
www.ti.com
Submit Document Feedback
Advertisement
Table of Contents
