Symbios Logic Scsi Configuration Utility; Default Settings You Can Change - HP X Class 500/550MHz Reference Manual

HP BIOS
Symbios Logic SCSI Configuration Utility
Symbios Logic SCSI Configuration Utility
NOTE The Symbios Logic SCSI Configuration Utility is only applicable for devices
connected to the 16-bit integrated Ultra-wide SCSI controller on the
LAN+SCSI Combo Board. Up to a total of 15 devices (internal and external)
can be supported by this controller via a 16-bit wide external connector and
an 8-bit narrow internal cable.
The Symbios Logic SCSI Configuration Utility lets you view and change the default
configuration for the host adapter, and all SCSI devices connected to it, or for individual
SCSI devices. If, while using this utility, you accidentally disable all the controllers,
pressing during the POST (after the memory test) lets you recover and configure
F6
settings.

Default Settings You Can Change

The following two tables show the configuration settings that can be changed. The first
table shows the global settings which impact the host adapter and all SCSI devices
connected to it. The second table shows the device settings which apply to individual
devices.
Table 4-1. Global Settings that Impact the Host Adapter and All SCSI Devices
Settings for the Host Adapter and All Devices
SCAM Support
Parity Checking
Host Adapter SCSI ID
Scan Order
Removable Media Support
CHS Mapping
Table 4-2. Device Settings that Apply to Individual Devices
Settings for Individual SCSI Devices
Synchronous Transfer Rate (MB/s)
Data Width
Disconnect
Read Write I/O Timeout (seconds)
Scan for Devices at Boot Time
Scan for SCSI LUNs
Queue Tags
102
Default Settings
On
Enabled
7
Low to High (0-Max)
None
SCSI Plug and Play Mapping
Default Settings
40
16
On
10
Yes
Yes
On
Chapter 4