10Bt/100Tx Lan Features; Remote Power On - HP X Class 500/550MHz Reference Manual

On the rear panel there is one RJ-45 connector. There is a LED which indicates the LAN
connection status as follows:
• Off - when there is no response (for example, when the LAN cable is not connected to
the network HUB.
• Blinking - during Autonegotiation
• Green (ON) - the connection has passed the Autonegotiation and a link has been
established between the LAN adapter and the network HUB/Switch.
NOTE Refer to the User's Guide for details concerning system configuration changes
necessary after installing a LAN adapter.

10BT/100TX LAN Features

Table 3-6. 10BT/100TX LAN Features
Feature
LAN Controller
RJ45 Connector
Remote Boot
ExtStart Connector
Remote Power On (RPO)
Remote Wake Up (RWU)
Wake On LAN (WOL)

Remote Power On

Remote Power On (RPO) is available at 10 and 100 Mbits per second.
Vstandby requirements supporting RPO
The Vstandby requirement for the HP network card supporting RPO, is: a power supply
able to deliver at least 720 mA on Vstandby output. This is the case for all HP V
systems.
Chapter 3
AMD PCNET-Fast+ chip
10BT/100TX autonegotiation
Protocols integrated in System BIOS
Connection to CPU board
Full remote power on with Magic Packet
Wake Up from Suspend state with Magic Packet
Enables a host computer, using Magic Packet technology, to remotely
(over the network) power on computers.
Interface Boards and Mass-Storage
SCSI/LAN Combination Board
Description
Drivers
ISUALIZE
79