Safety Warnings; Electrostatic Discharge (Esd) Precautions - HP Visualize J5000 Upgrade Instructions

WARNING
NOTE
NOTE
Getting Started

Safety Warnings

Safety Warnings
Removing the device cover may expose sharp edges in the
equipment chassis. To avoid injury, use care when installing
customer add-on devices.
Before performing removal/replacement procedures, position the
workstation on a cushioned flat, stable surface, such as a table top or
workbench.
Installing the recommended HP replacement part in your J5000
workstation does not affect the regulatory and safety classifications or
approvals listed in the original owner's guide.

Electrostatic Discharge (ESD) Precautions

To prevent damage to the J5000 workstation, observe all of the following
ESD precautions while performing removal and replacement procedures:
• Remove all ESD-generating materials from the work area in which
you will remove and replace the workstation field replaceable unit(s).
• Open the ESD materials provided with the replacement part kit.
Unfold the black conductive sheeting (antistatic mat) and place it
under a corner of the workstation.
• Wear a static strap to ensure that any accumulated electrostatic
charge is discharged from your body to ground. Attach the
static-grounding wrist strap by following the instructions on the
package. Attach the sticky end of the wrist strap to bare metal on the
rear panel of the workstation.
• Connect all equipment together, including the static-free mat, static
strap, clips attached to the wrist strap, nodes, and peripheral units.
6 Chapter 1