GLP impression X5 User Manual page 35

German Light Products®
Service
Live diagnostic
iQ.Service Connect
Test All
Test P/T
Test LED
Tests
Test Zoom
Test Fans (Auto)
Test Fans (Manual)
Test Encoders
Service Mode
Job offsets
Advanced
Reset counters
(Press and
hold for 3
secs.)
Save User Settings
Firmware push
(Fixture2fixture)
Load factory defaults
>>>Confirm<<<
Default settings are written in BOLD type
>>> Connect <<<
OFF
ON
Pan
Tilt
Zoom
Device
hours
Device
power
cycles
Max.
tempera-
tures
Air filter
Preset 1
Preset 2
Preset 3
>>> Confirm <<<
Rev. 20220720-01
Shows overview of fixture
information
Enables connectivity to
the GLP iQ.Service app.
Run test sequence of all
effects including pan and
tilt. Stop with BACK.
Run test sequence of pan
and tilt only. Stop with
BACK.
Run test sequence of all
LEDs. Stop with BACK.
Run test sequence of
zoom effect. Stop with
BACK.
Run fan self test. Tries to
detect fan errors, clears if
successful.
Manually test fans one by
one
Auto test for all encoders
Normal operation
Disable pan, tilt and
display timeouts (exit by
cycling power off and on.)
Create custom offsets in
home positions of all
effects. Default offset = 0
Confirm 2 Zero the device hours
seconds counter
Confirm 2 Zero the power cycles
seconds counte
Zero the max.
temperatures log (total
Confirm 2
max. temperatures = non-
seconds
resettable, max.
temperatures = resettable)
Confirm 2 Zero the air filter hours
seconds counter
Confirm 2
seconds
Saves current fixture
Confirm 2
settings as user settings
seconds
preset
Confirm 2
seconds
Push fixture's firmware to
all other fixtures of the
same type over the DMX
link
Reloads all factory default
settings and default fixture
configuration settings.
35