Installing The Board - HP Vectra VL5 3 User Manual

Installing the Board

# $ K +
1. Before you install a non-Plug and Play accessory board, run the ISA Configuration Utility in
the Plug and Play group in Windows.
NOTE PCI boards are configured automatically when installed in the PC.
2. Disconnect the computer's power supply cord.
3. Remove the computer's cover and power supply.
4. Find a free slot. Some boards may have preferred locations and special installation
instructions detailed in their manuals.
5. Unscrew and remove the slot cover. Store it in a safe place.
If the slot cover is tight, loosen the screws on the adjacent slots.
6. Hold the board horizontally by its "top" edge. Slide it into the board guide of the chosen slot.
Do not bend the board.
7. Align the board's connector with the slot's socket. Firmly press the board into the sock et.
Ensure the board's connector engages completely with the socket and does not touch components
on other boards.
8. Secure the board by replacing the slot cover screw.
If you loosened the screws on adjacent slots, tighten them.
9. If you install a VESA-standard video adapter board that uses the integrated video graphics
controller, connect the accessory board's cable to the VESA pass-through connector on the system
board.
10. Install any other accessories before replacing the cover.
#
InstallingtheBoard.30
$
Installing the Board
K
Installing the Board;accessory board;installing;VESA connector
+
SECTION3:0055
HP Vectra VL5 PC User's Guide - Part 2Error! No text of specified style in document.
33
{bmc help0028.bmp}
{bmc help0029.bmp}
{bmc help0030.bmp}
{bmc help0031.bmp}