Software Problems - HP Vectra VL5 3 User Manual

Software Problems

# $ K +
If You Have Forgotten the Passwords
If you forget either one or both of the passwords there are a few possible actions:
If you forget the User Password and the System Administrator Password is set and known:
1. Restart the PC. If the keyboard is locked, unplug the power cord and plug it in again.
2. Wait for the message <F2=Setup> .
3. Press [F2] to start SETUP.
4. Enter the System Administrator Password to enter the SETUP Menu.
5. Highlight the User Password field and set a new User Password.
6. Press [F3] to save the new User Password.
If you forget both the User Password and the System Administrator Password:
1. Switch off the PC.
2. Remove the computer's cover. (Refer to chapter 3.)
3. Set switch 4 (PSWRD) on the system board switch block to CLOSED. (Refer to chapter 5 for
the switch location.)
4. Switch on the PC and allow it to complete its startup routine.
5. Switch off the computer.
6. Reset switch 4 (PSWRD) on the system board switch block to OPEN.
7. Replace the computer's cover. (Refer to chapter 3.)
8. Switch on the PC and allow it to complete its startup routine.
9. After the Power-On Self-Test has completed, press [F2] when prompted to use SETUP.
10.Set new User and System Administrator Passwords.
11.Press [F3] to save the new passwords.
Related Topics:
If You Can't Start the SETUP Program
If Your Application Software Does Not Work
If Power Management Does Not Work
If the Date and Time are Incorrect
#
SoftwareProblems.56
$
Software Problems
K
Software Problems
+
SECTION4:0065
HP Vectra VL5 PC User's Guide - Part 2Error! No text of specified style in document.
60