HP Vectra VL5 3 User Manual page 47

Part 1
Hide thumbs Also See for Vectra VL5 3:
Table of Contents

Advertisement

Post Errors that may prevent the PC from starting
# $ K +
Error No.
Corrective Actions
0130, 0241
1. Ensure the configuration stored in CMOS has not been cleared by
0280
2. Run SETUP to correct the configuration information.
3. Replace the battery if the configuration is repeatedly lost.
4. If all the above fail to correct the problem, the system board may
Contact your service representative.
0250
1. Run SETUP to view the configuration and correct any obvious
2. If this fails to correct the problem, ensure the hardware is
3. If the hardware was changed, run SETUP to update the
61xx, 6500, 6510,
1. Ensure the memory modules are installed correctly (refer to
6520
8x06
2. If this does not fix the problem, initialize the system ROM (refer to
3. If the problem persists, the system board may need to be
Contact your service representative.
65xx, 66xx
1. Disable all shadowing in SETUP.
2. If this fails to correct the problem, the system board may need to
Contact your service representative
8xxx
1. Check that the hard disk drive has not been disabled in SETUP.
2. Check that the disk power and data cables are correctly connected
3. If the hard disk has not been detected, use the Custom
910B
1. You connected the flexible disk drive connector B: to the disk drive
2. Change the flexible disk drive connector to A.
#
PostErrorsthatmaypreventthePCfromstarting.43
$
Post Errors that may prevent the PC from starting
K
Post Errors that may prevent the PC from starting
+
SECTION4:0010
HP Vectra VL5 PC User's Guide - Part 2Error! No text of specified style in document.
47
the system board jumper (refer to chapter 5).
need to be replaced.
errors.
configured correctly. In particular, ensure the configuration stored
in CMOS has not been cleared by the system board jumper. Make
a written note of the configuration.
configuration information.
chapter 3).
"If You Can't Start the SETUP Program" in this chapter).
replaced.
be replaced
(refer to chapter 3).
parameters in SETUP.
and there is no connection to a drive A.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vectra vl 5/xxx - 3Vectra vl5

Table of Contents