If An Accessory Board Does Not Work - HP Kayak XA-s 02xx Troubleshooting Manual

HP Kayak XA-s 02xx PC Workstation - Troubleshooting Your HP Desktop PC Workstation
2 With a thin, solid rod, such as the end of a paper clip, push the drive's
manual eject button.
Using the manual eject feature.
The picture shows two possible
locations of the manual eject button.
3 The drive door is released, opening slightly. Carefully pull it open
fully and retrieve the disk.
4 To close the drive door, push it gently closed without forcing it. The
drive door may not close completely until it is fully functional (for
example, when the power comes back on).
5 If required, replace the drive's front bezel.

If an Accessory Board Does not Work

Carry out the following checks:
Check that the accessory board has been firmly installed in the slot.
•
Check that the accessory board has been correctly configured.
•
Check that the accessory board is not using memory, I/O addresses,
•
an IRQ, or DMA also used by the PC Workstation.
If Your PC Workstation Has a Hardware Problem
English
19