Circuit Configuration - Fike SHP 10-051 Product Manual

INSTALLATION
4.7

CIRCUIT CONFIGURATION

These columns define four basic operation modes selected by SW3. Position S1 (suppression versus
sprinkler) and S2 (sequential versus cross-zone detection). Switch position S7 and S8 allow further
customization.
NOTE: The Agent Release Module circuit and the Solenoids circuit can't be used concurrently.
S1: Suppression Mode (S1 = Off)
S2: Sequential (Off)
In #1 * Sequential Det.
In #2 * Seq. Det./ Supervisory
In #3 Manual Release
In #4 Abort In
Aud #1 Alarm
Aud #2 Pre-discharge
Aud #3 Release
Agt Rel ARM (S7 = Off)
Sol Solenoid (S7 = On)
Rel #1 Alarm
Rel #2 Trouble
Rel #3 Alarm
Rel #4 Pre-discharge
Rel #5 Release
Rel #6 Abort/Superv
Italicized Supervisory/Manual Release options are activated when switch S8 = On
* Clip the pertinent 0 ohm jumper if using 0 ohm bases or contact closure devices.
Relays are dry contact outputs which activate up on the given states listed above.
Relays 1-2 are on SHP controller. Relays 3-6 are on optional SRM4 relay module.
Alarm, Pre-discharge, Release, and Waterflow relays are latching (do not clear until reset).
Abort, Supervisory, and trouble relays reflect current system status (except for latching troubles).
Sequential Det: Sequential Zone detection circuit as described in Section 1.4.
Cross-Zone Det: Cross-Zone detection circuit as described in Section 1.4.
Superv(isory): Supervisory contact monitoring input circuit or indicating circuit.
Manual Rel: Manual Release contact monitoring input circuit. Overrides aborts.
Waterflow: Waterflow contact monitoring input circuit. Activates:
Abort In: Abort contact monitoring input. Abort definitions are at the end of this section.
ARM: Release circuit to fire GCA via Agent Release Modules (Fike P/N 10-1832).
Solenoid: Solenoid release circuit used with either two 12V Fike CO2 solenoids or listed
industry 24VDC solenoids.
Page 26 of 43
Rev. No: 3, 04/02
Sprinkler Mode (S1 = On)
Cross-Zone (On) Sequential (Off)
Cross-Zone Det. Sequential Det.
Cross-Zone Det. Seq. Det. /
ManRel
Manual Release Waterflow
Abort In Supervisory
Alarm Alarm
Pre-discharge Predis / Superv
Release Waterflow
ARM (S7 = Off) Disabled
Solenoid (S7 = On) Solenoid
Alarm Alarm
Trouble Trouble
Alarm Alarm
Pre-discharge Trouble
Release Waterflow
Abort Supervisory
a.) solenoid output
b.) Audibles: Waterflow, alarm, and pre-discharge
c.) Relays: Waterflow and alarm
SHP Product Manual
Manual P/N: 06-130
firealarmresources.com
FIKE CORPORATION
Silenceable
Cross-Zone (On)
Cross-Zone Det.
Cross-Zone Det.
Waterflow
Supervisory
Alarm Silenceable
Predis / Superv Silenceable
Waterflow Silenceable
Disabled Non
Solenoid Non
Alarm Non
Trouble Non
Alarm Non
Trouble Non
Waterflow Non
Supervisory Non
UL S2203
FM 0Z8A0.AY