Axminster WORKSHOP AW216TS Original Instructions Manual page 9

Fig 06-07
V
3. Locate the inner flexible hose (V) and two hose clips (M).
Place a clip over each end of the hose and secure the hose over
the extraction outlets, see fig 06-07.
Fig 08
W
4. Place the base plate (W) to the base of the saw (A) and
align the holes as shown in fig 8. Find the four threaded feet (T),
screw each foot in turn into the threaded holes in each corner
of the chassis, see fig 09 below.
T
WITH ASSISTANCE TURN THE SAW
ASSEMBLY OVER!
5. Lower the saw down, locate the side and rear extension
tables (B-C) and M8 bolts/washers (U). Line up the holes in the
side extension table (B) with the threaded holes to the side
of the main cast iron table. Insert the bolts with washers (U)
through the holes and secure the extension table (B) to the
main cast iron table, see fig 10-11-12.
M
A
Line up the holes
Locking nut &
washer
U
6. Repeat the procedure for the rear extension table (C).
Note: make sure you line up the machined slots in the table
with the 19mm mitre 'T' slots in the cast iron table. Secure
both extension tables together, see fig 13-14-15.
9
ASSEMBLY
Fig 10-11-12
B
Fig 13-14-15
C
Continues over...