Butterfly knob
12. Slide the fence (29) near the blade but not touching, tighten
the butterfly knobs, see fig 66-67. Note: check that the fence
does not come into contact with the riving knife.
13. Locate the fence distance stop (27). Loosen the clamping
handle, slide the assembly into the 'T' slot to the opposite end
of the fence (29) and secure in place, see fig 68-69.
Fig 68-69
90˚ Stop
14. Using a 90˚ square check that the blade is at 90˚ to the
fence assembly (29) and make adjustments until correct, see
fig 70.
Sliding table kit assembled
17
ASSEMBLY
27
Fig 70