Table of Contents
Advertisement
ASSEMBLY
104930 Optional Sliding Table Kit for AW216TS
106805 Optional Sliding Table Kit for AW254TS
1. Locate the carriage support brackets (20).
Offer up the elongated slots in both support
brackets with the threaded holes in the side
of the saw assembly (A). Using the supplied
Hex key (R) secure the bracket in place using
the threaded adjusters (21), see fig 42-43-44.
Fig 42-43-44
Threaded holes
AW216TS
20
a
AW254TS
2. Find the two height adjusting blocks (22), unscrew the
height adjuster thread & remove the locking nut to give you
access to the cap head bolt, see fig 45. Fix the blocks against the
saw using the threaded holes beneath each bracket, see fig 46.
Replace the height adjuster locking nut & screw the adjuster
thread, so it touches the base of the bracket (20), see fig 47.
3. Locate the sliding carriage (30), loosen the two cap head
bolts/nuts (a) on the brackets (20). Introduce the first two nuts
into the 'T' slot rails on either side of the carriage (30) and slide
on, repeat for the opposite end. Adjust the carriage to your
preference and nip up the four bolts, see fig 48-49.
Threaded
A
21
Threaded adjuster
21
Washer
Nut
adjuster
Washer
Support
Bracket
20
20
a
14
Cap head bolt
Height adjuster
22
30
Fig 45-46-47
Height adjuster
locking nut
Fig 48-49
Advertisement
Table of Contents
